HV-WP/HW-WP Series
Page 9
5. 1. Removing the ploe
5.1.
Removing
the
Pole
Caution
Remove the main power plug from the receptacle before removing the pole.
When removing the loadcell cable, do not pull the loadcell cable connector
forcibly and do not pull on the wires of the cable.
Do not bend the cable forcibly. Use care so that the load cell cable does not
touch the pan inside the base unit.
Avoid dust, static electricity and high humidity (or drops) because the inside
of the display unit is very sensitive.
Procedure
Step 1 Remove the power plug from the receptacle.
Step 2 Open the rear cover of the display unit.
Disconnect the loadcell cable connector gently.
Step 3 Remove the ferrite core and cable clamp from
the loadcell cable.
Step 4 Loosen the knobs to remove the display unit.
Step 5 Remove four 3mm screws from the bottom cover
of the bracket for HV-60KV-WP, HV-200KV-WP,
HW-60KV-WP, HW-100KV-WP, HW-200KV-WP.
Step 6 Carefully remove the load cell cable from the
pole and the bracket. Especially, use care with
the HV-15KV-WP, HW-10KV-WP so that the
connector is not pulled forcibly.
Step 7 Arrange the cable so that it does not touch to
the weighing pan in the base unit. The untied
cable is at least 2m long. The optional
extension loadcell cable (OP-02) is 5m long.
knob
Loadcell cable
Cable clamp
Ferrite core
Wind up 2 times
Screw and O ring
Connector
Pole
Bracket (Middle and large size)
Pole
Bottom cover
3mm screws
Summary of Contents for HW-200KV-WP
Page 72: ...Page 70 HV WP HW WP Series MEMO...