A&D SW-D, Setup Instructions

16

8. SETTING FUNCTIONS OR UNITS FOR USE

The indicator has CF function settings to specify the indicator performance. 
After installing the indicator, the indicator does not require resetting or changing of this 
CF function as far as it is used normally. 
If you want to maintain only the needed units, set using this function. 
The parameters set in the CF function settings and unit setting are maintained even if the 
power is turned OFF. 

8.1. Setting of the CF function 

1.  Refer to “7.1. Items of the calibration mode”, to enter the 

calibration mode. The indicator displays “

Cal5et

”. 

2. Press the 

MODE    key three times to display “

Cf

”. 

3. Press the 

TARE    key to display the setting item. 

4. Select the setting item and parameter using the following keys: 

UNITS      Proceed to next setting item. 

PRINT      Increases the number (+1) at the blinking digit. 

(Change the parameter) 

  When the currently stored set is changed, the STABLE 

indicator “

●

” turns off. 

  Changing the parameter using the 

PRINT    key at CF1, 

2, 8 or 12 is not available. 

5. Press the 

TARE    key to store the setting. After displaying   

“

end

”, the indicator displays “

Unit

” and proceeds to the unit 

setting mode. 

  To proceed, without storing the CF function setting, press 

the 

ZERO   key. After displaying “

Unit

”, proceed to the 

use unit setting mode.

(Display example: “

1110000

pcs”) 

6.  When the unit setting is to be performed, go to step 5 of 

“8.2. Setting the unit for use”.   
When the unit setting is not to be performed, press the     

ZERO

1

 key. After displaying “

Cf

”, the setting is complete. 

  To adjust to the designed scale specification, set other 

items by following the procedure described above. 

Item 

Parameter

Press

Press

Press

Press

three times