A&D UA-705, Instruction Manual

English  6

Using The Monitor 

Attaching The Arm Cuff 

1. Wrap the cuff around the upper arm, 

about 2 - 3 cm above the elbow, as 
shown. Place the cuff directly against 
the skin, as clothing may cause a faint 
pulse and result in a measurement 
error. 

2. Constriction of the upper arm, caused 

by rolling up a shirtsleeve, may prevent 
accurate readings. 

3. Confirm that the index 

points within 

the proper fit range. 

How To Take Proper Measurements 

  For the most accurate blood pressure 

measurement: 

Sit comfortably at a table.   
Rest your arm on the table. 

Relax for about five to ten minutes 
before measurement. 

Place the center of the cuff at the same height as your heart. 

Remain still and keep quiet during measurement. 

Do not measure right after physical exercise or a bath. Rest for twenty or 
thirty minutes before taking the measurement. 

Try to measure your blood pressure at the same time every day. 

Measurement (Operation) 

  During measurement, it is normal for the cuff to feel very tight.   
  Select a measurement mode (operation of the device). 
  Normal measurement with storing data :

 .....................................

Press the 

START

button. 

 Recalling 

data 

:

 .........................................

Press and hold the 

START 

button to recall data. 

  Clearing data :

 ........................................................................

Remove the battery and re-install it. 

After Measurement 

  After the measurement is completed, remove the cuff and record your data, 

then press the 

START 

button to turn off the power. 

Note:  The device is an automatic power shut-off function, which turns the power 

off approximately one minute after measurement. 

Allow at least three minutes between measurements on the same person. 

Rolled up shirtsleeve 

2 -3 cm 

Constriction of the Upper Arm

Air Hose

Cuff 

Index

and Proper fit range