Page 42 May 2014 – TD 293 OPERATING MANUAL – SmartGuard 5100/5120/5300/5320
Table 6-1 User Maintenance settings for Serial sensors. Some settings are not applicable for all sensor applications;
please refer your sensor operating manual.
Property
Comment
Mandatory:
Node description
Type a description. Default is product name and serial number
Port Settings:
Baud Rate
Set appropriate value for the sensor
Data Bits
Set appropriate value for the sensor
Stop Bits
Set appropriate value for the sensor
Parity
Set appropriate value for the sensor
Flow Control
Set appropriate value for the sensor
Wake up Settings:
Enable Wake up Control
Check if a wakeup char is required to put the sensor into operation
Wake up Char
Select a wakeup character
Wake up Char Delay (ms)
Type the delay time (0ms – 1000ms)
Power Settings:
Enable Power Control
Enable SmartGuard to control sensor power.
Continuous Power
Check if continuous power is required
Warmup Time (ms)
Set the time required from power up until the sensor is ready
Minumum Power off Time (ms)
Set value for minimum time power needs to be off before repowered
Enable Soft Start
Enable Soft Start to increase power slowly to full power setting
Soft Start Time (ms)
Type the time needed for soft start
Sensor Session Settings:
Enable Session Control
Check to enable session control
Start up Command
Type a command to be transmitted after each power up
Start up Time (ms)
Time required for the sensor to be ready after the start up command
Shut down Command
Type a command to be transmitted after last received data in a
recording interval (if continuous power or not enabled power control)
Shut down Time (ms)
Time required to shut down
Polled Data Settings:
Enable Poll Data Control
Check to enable polled data
Poll Data Command
Type
the Command String that must be transmitted to the sensor in
order to receive the data message. E.g.
Get
Data Inhibit Window (ms)
Set the length of a time window in which to neglect transmitted data
just after a poll command (a time window between poll command
and data receive window).
Data off Command
Command to stop sensor from output data
Data Receive Settings:
Data Receive Window (ms)
Set the length of the time window for the SmartGuard to receive data
from sensor
