A&I Products A-C7481A Installation Manual Download

Page: 5 / 7

3. The side mount plates will mount directly to the canopy frame with the (4) 3/8” bolts and (4) 3/8” nuts

There are multiple positions to attach the side plates to the frame, this is determined by the angle of the

ROPS and personal preference. If the ROPS angles forward, use holes toward the center of the canopy frame.

If the ROPS angles to the rear, use holes towards the rear of the canopy frame. These are recommended, but

can be adjusted based on operator preference. After this step is complete move to

step 7

2. If the ROPS measured 35” the side mount plates will mount directly to the canopy frame. The side mount

plates are reversible to accommodate forward and rear angled ROPS. The side mount plates are slotted, this

will allow adjustment to level the canopy once installed. The orientation of the side mount plates are shown

below (the curved edge will match the angle of the ROPS).

Fig. 2

Fig. 3

Front

Back

Summary of Contents for A-C7481A

Page 1: ...CANOPY INSTALLATION MANUAL A C7481A CANOPY KIT ALUMINUMTREAD PLATE A C7481B CANOPY KIT BLUE A C7481G CANOPY KIT GREEN A C7481O CANOPY KIT ORANGE A C7481R CANOPY KIT RED A C7482R CANOPY KIT DARK RED ...

Page 3: ... Bottom Bracket 2 3 A C35830 Side Mount Plate 2 4 A C35850 Top Bracket 2 5 A C35840 Hardware Kit 3 8 Lock Nut 16 3 8 x 1 Bolt 16 1 2 Washer 8 1 2 Lock Nut 8 U Bolt 2 5 x 3 4 U Bolt 3 x 3 4 HARDWARE KIT COMPONENTS Use this chart to identify individual component quantities used 5 2 3 4 1 ...

Page 4: ...es that are 2 1 2 3 in size It is also designed to fit ROPS that are angled up to 33 forward or backwards 1 Measure the overall width of the ROPS to determine the bracket configuration If the width measures 35 then only the side mount plates are required proceed to the step 2 If the width is greater or less than 35 move to step 4 Fig 1 ...