A&I Products A-C7481A Installation Manual Download

Page: 6 / 7

4. If the width of the ROPS is greater or less than 35” wide, the top and bottom brackets will be needed. These

brackets will allow adjustment to fit ROPS that are 27” to 40” in width. Use (6) 3/8” bolts and (6) 3/8” nuts

per bracket, two bolts and nuts are required for each slot. The orientation of the side mount plates will

depend on the angle of the ROPS.

Fig. 4

5. The side mount plates are reversible to accommodate forward and rear angled ROPS. The side mount plates

are slotted, this will allow adjustment to level the canopy once installed. The orientation of the side mount

plates is shown below (the curved edge will match the angle of the ROPS).

Fig. 2

Summary of Contents for A-C7481A

Page 1: ...CANOPY INSTALLATION MANUAL A C7481A CANOPY KIT ALUMINUMTREAD PLATE A C7481B CANOPY KIT BLUE A C7481G CANOPY KIT GREEN A C7481O CANOPY KIT ORANGE A C7481R CANOPY KIT RED A C7482R CANOPY KIT DARK RED ...

Page 3: ... Bottom Bracket 2 3 A C35830 Side Mount Plate 2 4 A C35850 Top Bracket 2 5 A C35840 Hardware Kit 3 8 Lock Nut 16 3 8 x 1 Bolt 16 1 2 Washer 8 1 2 Lock Nut 8 U Bolt 2 5 x 3 4 U Bolt 3 x 3 4 HARDWARE KIT COMPONENTS Use this chart to identify individual component quantities used 5 2 3 4 1 ...

Page 4: ...es that are 2 1 2 3 in size It is also designed to fit ROPS that are angled up to 33 forward or backwards 1 Measure the overall width of the ROPS to determine the bracket configuration If the width measures 35 then only the side mount plates are required proceed to the step 2 If the width is greater or less than 35 move to step 4 Fig 1 ...