28
Multi-Wing W Series Black Glass
Reinforced Polypropylene Fan Blade Pitch
Angle Setting Instructions
Contact the AAON parts department to
acquire the new pitch pins for the fan blades.
Note original position of retaining plates,
center boss and all hardware including
additional hardware used for balancing.
1.
Remove all the bolts and nuts.
2.
Determine blade rotation – on the concave
side of the blade is a blade marking showing
6WR, 6WL, 7WL, 7WR, or 9WR. The “L”
and “R” denote the rotation of the blade.
3.
Replace the pitch insert in the blade root
with an insert of the desired pitch.
Figure 13 - Pitch Insert
4.
Replace blades to their original location.
5.
Replace all nuts, bolts, and washers on the
fan hub.
6.
Replace retaining plates and center boss to
original location.
7.
Tighten nuts and bolts to 14 ft-lbs of
torque.
Fan Assembly Bushings
The fan assembly bushings should be
tightened to the specifications listed in the
following table.
Table 7 - Fan Assembly Bushing Torque
Specifications
Bushing
Tightening Torque
(in-lbs.)
H X 1.125"
95
H X 1.375"
95
SH X 1.125"
108
SH X 1.375"
108
SD X 1.125"
108
SD X 1.375"
108
SD X 1.625"
108
SD X 1.875"
108
SK X 2.125"
180
Summary of Contents for LN Series
Page 49: ...49 ...
Page 50: ...50 ...
Page 57: ...57 Pressure Temperature Limits Flo Trex Cross Section ...
Page 62: ......