5
GENERAL INFORMATION
1.
Carefully remove the crating and packing materials. CAUTION! Be careful when
cutting steel banding material as items may become loose and fall causing personal
harm or injury.
2.
Identify the components and check for damage or shortages. If damage or
shortages are discovered, contact distributor immediately.
Save the shipping bolts
for use in the installation
.
Packing:
*The
hoist
packed into one heavy rack and one carton box on it.
*Every rack with two runways, four columns with covers, two cross bar, two ramps,
two front stops, one long lock linkage rod, and a accessory box.
*There is the hydraulic motor in one of the boxes.
3.
Hoist
location - check with building owner and / or architect’s building plans when applicable. The
hoist
should be located on a relatively level floor with concrete sufficiently cured.
Suggestion:
(1) The floor be flat and without gradients (maximum of 10mm tolerance between the two base
plate of the columns)
(2)
There are no cracks within
965mm
and no seams within
150mm
of the base plate.
(3)
The concrete is recommended with following dimension:
4000mm
L *
1000mm
W *
200mm
H.
Remember any structure is only as strong as the foundation on which it is located.
4.
Check for ceiling clearance.
Suggestion:
At least
127 mm
left between the top of a car on the
hoist
and the ceiling.
Check for clearance in the front and rear of vehicle when on
hoist
- will the garage door
open. Suggestion:
At least
600 mm
space left between the edge of the column and the wall.
At least
3650 mm
space left between the central line of the columns and the wall.
( At least
915 mm
space for walking left between the front or the rear of the vehicle and the
wall. )
5.
Check the power supply. The voltage phase and proper amperage requirements for the motor
shorn on the motor plate. Only a certified electrician should perform the wire connection.
Suggestion: For a 2
40
V / 50Hz, single phase, 2.2Kw motor, the rated current will be 15A
mp
.
Basic Specification
Description
Capacity
Lifting
Time
Lifting
height
Four-Post
Flat Deck Parking
Hoist
3200kg
( about )
100 Sec
(3600 mm)
