9
/
13
you will have to replace the holding device.
To do this, follow the next steps:
a. Lift up the far end of the wheel fork, then take it out from the groove on
the carriage.
b. Insert the frame adaptor into the groove (Fig. 9).
Fig. 9
Fig. 10
10. While using the frame adapter to lift up the vehicle, remember to position
the adapter on the gravity center line of the vehicle. That is to lift up the
whole side of the vehicle.(Fig.10)
Suggestion:
a. The position on the frame near under the vehicle’s side-view mirror is a
good place for the adapter..
b. Remember that the holding place has to be a strongest area of the
frame with stability. Never to be in the center of the vehicle or at the
back.
Summary of Contents for AutoLift AL-182093
Page 4: ...7 13 Fig 3 Fig 5 Fig 4 Fig 6 Now the hoist is ready for use ...
Page 7: ...10 13 PARTS DRAWING ...
Page 8: ...11 13 ...
