‐ ‐
11
3. Preparing and installation
3.1. Site Selection
The hydraulic motorcycle
hoist
is designed only for indoor use. Application in a room with
explosion hazard is not permitted. Setting in a wet place, a car wash center for instance, is
forbidden.
3.2. Surface Condition
The
hoist
should be installed on level ground with a concrete surface free from as many
defects as possible to prevent unit from tipping or rocking.
Failure in accomplish the foundation requirement may cause the
hoist
instability
or personal injury. Installing on asphalt, soft clay floor or near the expansion gap
is prohibited.
3.3. Necessary Tools
Rubber Hammer, Sockets and Open End Wrenches. Ratchet Driver, Vice Grips
3.4. Personal Protective Equipment
Always wear proper protective Equipment like working suit, shoes, gloves & glasses, etc.
3.5. Installation Instruction
1.
Unpacking
Open the carton. Using a forklift to take out the bench then move to desired position (Fig.
4a, 4b) and the
lift
up the upper platform.
Fig.4a
Fig. 4b
Fig. 5
2.
Assembling
a.
Loosely attach the vice rails in the appropriate holes in the front deck of
hoist
( Fig.5).
