AAQ AutoLift AL-900DD, Installation Manual Operating Instructions

This 

Safety Operating Procedure

 does not necessarily cover all possible hazards associated with the machine and should be used in conjunction with 

other references

.  It is designed to be used as an adjunct to the operation in the safety procedures and to act as a reminder to the operatior prior to 

machine use.

SAFETY OPERATING PROCEDURES 

Vehicle Hoist 

DO NOT

use this machine unless the operator has been 

thoroughly instructed in its safe use and operation. 

Safety glasses must be worn at all 
times in work areas.

Long and loose hair must be 
contained.

Sturdy footwear must be worn at all 
times in work areas.

Close fitting/protective clothing must 
be worn.

Rings and jewellery must not be 

worn.

Do not stand on hoist whilst hoist is in 
operation. 

A vehicle hoist must not be operated unless it has a current certificate of inspection. 

PRE-OPERATIONAL SAFETY CHECKS 

1. Ensure that vehicle hoist has operating and maintenance instructions permanently located

and clearly visible. 

2. The equipment must be used in accordance with manufacturer’s instructions.
3. Check the capacity of the hoist compared to the weight of the vehicle. If vehicle is too

heavy, do not proceed.

4. Ensure the area is clean and clear of grease, oil, and objects that may be a slip/trip hazard.
5. Familiarise yourself with and check all machine operations and controls.
6. Check all safety devices are in good condition.
7. Ensure support arms are capable of being locked in position.
8. Ensure rubber pads are in good condition on all load points.
9. Faulty equipment must not be used. Immediately report suspect equipment.

OPERATIONAL SAFETY CHECKS 

1. Centre vehicle on hoist, ensuring that the weight is evenly distributed to the front and rear.
2. Identify the correct jacking points.
3. Only one person shall operate the hoist at a time.
4. Ensure hoist area is clear of people and equipment before operating.
5. Never leave the hoist running unattended.
6. Check vehicle stability by looking at the jacking points.
7. Engage and check for the correct engagement of the locks.
8. At the completion of work lower the vehicle hoist and ensure all equipment is left in a safe

position.

HOUSEKEEPING 

1. Switch off equipment.
2. Leave the equipment and work area in a safe, clean and tidy state.

POTENTIAL HAZARDS



Falling objects 



  Trapping hazards  



 Crushing 

hazards 



 Entanglement 

hazards