16
e. prepared
f. for adjustment of installation later.
D
．
Installation of hydraulic pumping station:
Install the hydraulic pumping station on the upright post welded with soleplate and fix by screw.
Connect hydraulic oil pipes with the primary platform and joints of cart hydraulic cylinder
respectively and tighten the nut on the joints connected with the primary platform.
E
．
Steel rope tension adjustment:
Jog to raise the lifting platform to proper height, remove the support under the platform and lower
the platform to the minimum height. Adjust the steel rope nut and make the tension of four steel
ropes be the same. Notice! Before
．．
．
．
．
．
jogging
．
．
．
．
．
．
．
to
．
．
rise,
．
．
．
．
．
pay
．
．
．
special
．
．
．
．
．
．
．
attention
．
．
．
．
．
．
．
．．
to
．
．
the
．
．
．
position
．．
．
．
．
．
．．
of
．
．
steel
．
．
．
．
．
rope.
．
．．
．
．
See
．
．
．
whether
．．
．
．
．
．
．
it
．
．
is
．
．
correct
．
．
．
．
．
．
．
and
．
．．
ensure
．
．
．
．
．
．
the
．
．
．
steel
．
．
．
．
．
rope
．
．．
．
is
．
．
in
．
．
corresponding
．
．
．
．
．
．
．．．．
．
．
．
sliding
．
．
．
．
．
．
．
wheel
．．
．
．
．
groove
．
．
．．．
．
(refer to
Fig. 4).
F
．
Adjust the space between the upright posts and beam:
a. Raise the platform by about 200mm, adjust the space between the upright posts and beam.
In longitudinal direction (direction to load the vehicle), the head of the beam should be at
the middle of upright post notch to make the clearance between limiting stoppers at two
sides be the same. In horizontal direction, let the limiting stoppers approach the side face of
the upright post with a distance of about 2-3mm (see the Fig.).
b. Adjust the upright posts to be perpendicular to the floor:
a) Use the steel tape to measure the longitudinal and horizontal distance at upper extreme and
lower extreme of the posts respectively. The distance error should be not more than 5mm. If
necessary, use the adjusting washer supplied with machine to adjust. During adjustment,
ensure that the distance at upper extreme should be not less than lower distance. In
consideration of the deformation of the lift due to load, it is doable to increase the distance
at upper extreme within required error range.
b) According to the position of upright posts, use the Φ18mm percussion drill to make the hole
for anchor bolt with depth of about 110mm.
c) After drilling holes, use the brush and compressed air to clear the powder in the hole and on
the floor.
Summary of Contents for SXJS4019A
