Beacon Multifuel Stoves
17
INSTALLATION
FIREBOX LINER PANELS
The Beacon Multifuel stove uses firebox liner
panels to the sides and back. The throat plate sits on
top of the side and rear panels (fig 9). These should
come fitted to your fire, if however they are not
proceed as follows to fit them.
•Open the main fire door and ensure the cast static
grate is correctly fitted into both side lugs.(Fig 10)
•Set the 1x rear liner into the stove, this liner sits on
a ledge behind the static grate.
•Insert the 2x side liner panels, again these sit on
the side landings behind the top edge of the grate.
(Fig 11)
•Fit the throat plate with the single bend and two
cut outs to the front facing up. The projecting lugs
sit on top of the side liners. The long centre tab on
the back edge rests on the rear liners. The shorter
turn-down tabs against the vertical face.(Fig 12)
Note: Neither the rear firebox liners nor the side
firebox liners are "handed", both faces are
suitable for direct contact with the fire.
Note: Cracking of lining panels does not effect
efficiency.
Fig. 9
Beacon multifuel liners and throat
plate.
Fig. 10
Fig. 11
Fig. 12
REMOVAL OF THE THROAT PLATE
Blocked chimneys cause dangerous fumes to
escape. Remove throat plate at least monthly to
clean. Keep chimney and flue ways clear.
