Page 20
Aarrow Sherborne GSL CF
INSTALLATION INSTRUCTIONS
How to arrange the logs -
1) Position the rear log matrix (Item A) in
the centre at the rear of the burner. The
base of the matrix should slot down behind
the burner. See Fig. 15.
2) Lay the Y shaped log (Item D) to the right
hand side of the burner. Ensure that the Y
open section is uppermost and is resting
onto the cut out flat area to the right of the
rear log matrix. The base should be
approximately 30mm from the front of the
stove window opening. See Fig. 15.
3) Take the curved log (Item C) and place
this to the left hand side of the burner. Make
sure that the base of this log is again
approximately 30mm from the front of the
stove and the upper end of the log is resting
on the grooved notch within the rear log
matrix. See Fig. 15. Note, there should be a
gap between, both side logs when resting
correctly on the rear matrix.
Fig. 15.
4) Next, scatter the loose embers onto the
burner area.
Take care not to obstruct the
pilot assembly.
5) Lay the central log, from the centre front
of the burner to the rear of the stove. Sitting
the upper portion of the central log onto the
edge of the upper corner of the curved left
hand log.
See Fig. 16., Note, the top resting position of the
central log is angled to the left.
Fig. 16.
6) Place the 2x smaller twigs as shown in Fig.
16. Note the bottom of the twigs rest between
the stove body and burner. Take care with the
right hand twig to avoid impinging upon the pilot
assembly.
7) Take the remaining small twig and large twig
and place as shown in Fig. 17. The log layout is
now correct and should look like the picture
below.
Fig. 17.
NOTE
, take care, not to disturb any of the logs
positions during the fitment of the glass panel,
otherwise this will have to be removed and the
logs re-positioned again.
Rear Matrix
