USER INSTRUCTIONS
Page 37
Aarrow Sherborne GSL CF
TO IGNITE THE BURNER
Step 2.
With the pilot lit, turn the control knob
„A‟ to the large flame position and release. This
will ignite the burner (See Fig. 31d). On initial
lighting or after a period of non use, there may
be a short delay of 5 or 6 seconds to allow the
burner chamber to fill with gas, before ignition
takes place, this is perfectly normal.
To achieve the desired heat setting, turn knob
„B‟ to suit. Turn anti
-clockwise to increase input
and clockwise to decrease input.
Fig. 31d
B
A
MIN
MAX
NOTE:
Between the Max and Min burner
settings, an infinitely variable flame height is
achievable.
NOTE:
Condensation may form on the glass
panel during initial ignition of the burner, this is
normal and due to the moisture in the
atmosphere. This will disappear within 10
minutes of firing.
TO TURN THE STOVE AND PILOT OFF
COMPLETELY
Step 3.
Turning control knob „A‟ to the small
flame setting (pilot flame), depress and turn to
off position, then release. (See Fig. 31e)
Important
, when the control knob „A‟ is turned
to the off position, a built in safety lock is
activated which will prevent you from turning
the control knob for 60 seconds.
Do not try to force the control, wait the 60
seconds.
Fig. 31e
NOTE:
If the pilot is extinguished either
intentionally or unintentionally, no attempt to
re-light the gas should be made until
at least 3
minutes
has elapsed.
NOTE:
During the initial firing, the stove will
give off non-toxic fumes, when first used. This is
perfectly normal and will disappear after the first
few hours. It is advised to ventilate the room by
opening doors and windows to prevent irritation
to the user.
NOTE:
The fire doors can be opened during
operation, for a greater viewing area to the
flame picture, this does not effect the
operational performance of the stove.
NOTE:
During operation, the metal surfaces of
the stove will be
HOT,
a stove HOT glove is
supplied with the stove and can be used to
open the doors if required. (See Fig. 31f)
Fig. 31f
CLEANING OUTER SURFACES
It is best cleaned using a soft brush. Do not
allow moisture to remain on the stove while cold
or surface rust may occur.
CAUTION
