USER INSTRUCTIONS
Page 40
Aarrow Sherborne GSL CF
MANUAL MODE (MAN IN DISPLAY) FOR MANUAL FLAME HEIGHT
ADJUSTMENT
Press „
X
‟ to turn on the stove main burner or to increase the flame height.
Press „
Y’
to decrease the flame or to turn down to pilot.
To incrementally increase or decrease the flame height, lightly tap either the „
X’
or „
Y’
buttons.
The „SEND‟ symbol appears in the upper left corner of the display when either large
buttons are depressed.
The
LED
of the remote control receiver flashes when knob „B‟ of the valve reaches its
end stop, indicating that maximum travel has been reached.
AUTOMATIC MODE (AUTO IN DISPLAY) FOR TEMPERATURE CONTROL
Briefly press
AUTO.
The set temperature will appear briefly before the display reverts to
the room temperature mode.
TIMER MODE (TIMER IN DISPLAY)
During heating periods, P1* and P2* the temperature is continued in the same manner
as in the automatic mode.
When the timer programme turns to P1) or P2) (heating cycle off) the motor will turn the
valve to pilot and there is no temperature control. This minimizes battery consumption.
You may press
AUTO
to verify the set temperature and then press
TIMER
to return to
timer mode.
You may press either the „
X
‟ or „
Y
‟ button from any mode for manual override.
To prolong battery life we recommend switching the remote transmitter to manual mode
and turning the stove to pilot with knob „
B
‟ before turning the appliance off. If the remote
transmitter is left in automatic or timer mode, the batteries will continue to be used when
the appliance is off.
CHANGING THE BATTERIES
If „
BATT’
appears in the upper right hand corner of the display or if the red led light of the
receiver becomes faint please change the batteries in either or both the transmitter or
receiver.
TRANSMITTER
, Slide back the handset battery compartment cover, remove the used
battery, insert and connect a suitable new 1no. battery (9V / 6F22) and replace the
cover. See Fig. 33.
RECEIVER
, Again slide back the battery compartment cover, remove the used batteries
and replace with new 4no. (1.5V AA) batteries and replace the cover. Please ensure
correct polarity with the battery terminals. See Fig. 34.
NOTE:
If the batteries lose power, the flame height can be adjusted by manually turning knob
„B‟, see page 36.
