USING THE HEATER
Switching on your heater
•
Ensure before connecting to the mains, that
all the switches are in the
OFF
position.
Located on the right hand side of the heater you
will find the switches to operate the fire.
OFF ECONOMY
FLAME
ON
1kW
2kW
(A)
(B)
(C)
The first switch ‘A (as indicated in the diagram
above), switches on the fire and operates the
flame effect. If you only require the flame
effect with no heat, ensure switch ‘B’ is in the
centre position and switch ‘C’ is in the flame
position.
•
For Economy setting
- Switch B to ECONOMY.
Leave C to FLAME. You will hear the fan running
at a lower speed and will feel a low heat coming
from the grille.
For 1kW setting
•
Switch (B) down to 1kW, leave ‘C’ set to
flame. You will hear the fan speed up and feel
an increased amount of heat coming from the
grille.
For 2kW setting
•
Leave ‘B’ set at 1kW and switch ‘C’ +1kW.
Again you will continue to hear the fan and feel
more heat from the grille.
Note:
Switches ‘B’ and ‘C’ will not operate
without switch ‘A’ being on.
THERMOSTAT OPERATION
To set the room temperature, turn the knob
fully clockwise to the ‘MAX’ position.
When the room is at the desired temperature,
turn the knob slowly towards the ‘MIN’
position until the thermostat clicks. The heater
will now maintain the selected temperature.
MAINTENANCE
WARNING - BEFORE UNDERTAKING
ANY MAINTENANCE OR CLEANING,
DISCONNECT FROM THE POWER
SUPPLY.
CARE
Do not use water, detergents, abrasive cleaning
powder or polish of any kind on the body of the
heater. Lightly brush with a medium dry brush.
TROUBLESHOOTING
No Heat or Light
• Check heater is plugged in and switched on at the
mains.
• Check the switches are correctly set.
• Check the 13A fuse in the plug. Replace if
necessary.
Light but no Heat
• The thermostatic safety cut-out has operated. This
will re-set after a short period of time, when the
fire cools.
• Ensure the air supply and venting are not
restricted.
• The thermostat may have cut out or maybe set to
high for the room temperature. Please refer to the
‘thermostat operation’ paragraph in these
instructions.
• If still blowing cold air, unplug the heater and
phone our helpline.
No Flame-effect
• Unplug the heater and phone our helpline.
Noise from the fans
• Unfortunately there is always some noise from the
fans, we have done our utmost to reduce this but
they will never be completely silent.
4
Nouveau Electric Stove
OPERATING
