Network Settings
41-001160-00, Release 2.1, Rev 04
4-37
Configuring Network and Session Initiation Protocol (SIP) Features
Configuring the IP Phones
Configuring VLAN (optional)
Use the following procedures to configure VLAN on the IP phone.
Note:
VLAN is disabled by default. When you enable VLAN, the IP
phones use the default settings for each VLAN parameter. You can
change the default settings if required using the following procedure.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
“Virtual Local
Area Network (VLAN) Settings”
on
page A-26.
IP Phone UI
Step Action
1
Press
on the phone to enter the Options List.
2
Select
Administrator Menu.
3
Enter your Administrator password.
Note:
The IP Phones accept numeric passwords only.
4
Select
Network Settings.
5
Select
VLAN Settings.
To globally enable/disable VLAN and set priority for non-IP packets
:
6
Select
VLAN Enable
.
7
Press
Change
to set VLAN Enable to “
Yes”
to enable or “
No”
to disable. Default is “
No
”.
8
Press
Done
to save the changes.
9
Select
Phone
VLAN
.
10
Select
VLAN
Priority.
11
Select
Other
and enter a non-IP priority value from
0
to
7
for non-IP packets.
Default for this field is
5
.
12
Press
Done
(3 times) to return to the VLAN Settings menu.
