9
Installation
USB and external charging connection
Not Aastra 610d, 612d
: A mini USB connection (2.0) is located at the bottom right. This has two
functions:
• as an interface for connecting to a PC to load data from or to the device, for example. If the hand-
set is connected to a PC, the battery is charged at the same time. The charging process is, howe-
ver, slower than if the handset is charged in the charging unit.
• as a connection socket for a USB charging device (see Accessories, page 83) to charge the handset
even when it is in a leather pouch. The charging process is also slower here than charging in the
charger cradle.
Only use a shielded USB cable of the type “USB 2.0 A on USB Mini B”.
Aastra 630d/632d - USB connector: To remove the sealing cover
The opening of the USB connection in the Aastra 630d is closed with a captive cover. If the USB cable
is not in use, please close the opening so the device can be used in accordance with its protection
class.
Remove the sealing cover from the device by pulling it out on the
upper
edge.
Never pull it out on
the bottom edge.
Connecting the charging unit
Aastra 610d, 612d, 620d, 622d, 650c
: This handset can be used without any changes to the char-
ger cradle.
Aastra 630d, 632d
: To use this handset, you must
remove the two lateral guides in the charger cradle.
They are easy to lift on the inside edge using a finger-
nail or a paper clip.
The plastic guides can also be removed, by pushing a suitable
screwdriver into the slits on the bottom of the charger.
Connect the plug-in power supply to the charger cradle and place the connection cable through the
cable guide. Place the charger cradle on a non-slip surface. Change the plug of the power supply
unit if necessary (see below).