Ascotel® IntelliGate® 150/300 as of I7.9
Expansion Stages and System Limits
39
sy
d-
021
0/1.
7
– I7.
9 – 1
2.
2009
3. 3. 3
Wiring Adapter
The wiring adapters route the interfaces of the various interface cards with the
right connection diagram to the RJ45 sockets on the front panel. The adapters are
fitted to WA1...WA4 sockets.
Fig. 13
Types of wiring adapters
There are four types of wiring adapters, of which two (WA-TS0 and WA-TS1) have
different plug-in orientations. This determines the ratio of S interfaces to T inter-
faces.
Note
A configuration with wiring adapter is mandatory. An incorrect or missing
configuration generates the corresponding error display on the LED dis-
play (F1...F4).
Tab. 12
Wiring Adapter
The assignment to the RJ45 sockets depending on the Wiring Adapters is shown in
The mounting of a component such as a LAN switch module represents a special
case. It is fitted to two neighbouring wiring adapter sockets (WA0...WA4) and can
be used together with one or two AD2 terminal cards. The LAN switch module then
routes the AD2 interfaces together with the RJ45 sockets to the RJ45 sockets of the
front panel
1)
Type
Use with...
Remarks
WA-TS0
TIC-4TS, TIC-2TS, ESST-2
1)
1)
On the ESST-2 terminal card the jumper must always be fitted in position T (see
).
Included in the equipment supplied with TIC-
4TS and TIC-2TS
WA-TS1
TIC-4TS, TIC-2TS, ESST-2
, ODAB
Included in the equipment supplied with ODAB
WA-2W
Mainboard interfaces, TIC-4AB, TIC-2AB,
ETAB4, EAAB2, EADP4, EAD4C, EAD4V
Included in the equipment supplied with TIC-
4AB, TIC-2AB, ETAB4 and EADP4 (with ETAB4
and EADP4 only with order variant A150/300).
WA-1PRI
TIC-1PRI
Included in the equipment supplied with TIC-
1PRI
WA-TS0
WA-TS1
WA-2W
WA-1PRI
