Installation and First-Time Operation
63
Installation and First-Time Operation
Putting Your Phone into Operation
Note: Plug designs vary from country to country.
Logging Your Phone on
Your system administrator has to prepare the system before you can log on your phone.
Connecting your handset to the phone
1. Plug the connector at the rippled end of the handset cord into the socket near the handset's voice
microphone.
2. Plug the connector at the loose end of the cord into the small socket on the underside of the phone.
Connecting your phone to the system
1. Plug the connector on the phone cord on the underside of the phone into the socket with the phone
symbol.
2. Feed the cable through the strain relief provided.
3. Plug the other end of the cable into the phone socket outlet.
4. Ask the installation engineer to set the channel selector switch located under the write-in label cover.
Labelling Configurable Keys
The last page of the Operating Instructions contains labels for the configurable keys.
Proceed as follows:
1. Make a copy of the last page of these Operating Instructions and cut out the label.
2. On the label make a note of the stored functions or of the names corresponding to the numbers
stored.
3. Carefully remove the transparent cover next to the configurable keys.
4. Place the label into the recess next to the configurable keys.
5. Carefully replace the transparent cover.
