CM-16 Installation
The installation process is divided into three sections A, B, and C. If you follow the steps in order, the Handset and Antenna Unit will
properly synchronize with the M1 2616 port. At this time per Figure 2, prepare the handset by removing the battery cover and placing
the battery near the handset so you can connect it quickly in step B5.
A. Configure the 2616 Port and wall jack
If you have not already configured and verified a 2616 port, do so now. The Antenna Unit will not operate unless connected to a
working M1 circuit and the handset won’t work or even charge the battery properly unless the Antenna Unit is operational first.
B. Antenna Unit Connections
The Antenna Unit must be connected to a known working M1 port configured for a 2616 wired set. Where possible, verify the port
and key assignments by using a 2616 set before connecting the CM-16 to that jack.
Refer to Figure 1 and connect the components in this order.
1)
Plug one end of the 6 conductor cord (supplied) to the Antenna Unit
2)
Plug the other end of the 6 conductor cord into the jack on the Power Adapter Assembly
In the next two steps certain LEDs on the Antenna Unit should light up, so watch for the appropriate LED response.
3)
Plug the short 2 conductor line cord tail of the Power Adapter Assembly into the 2616 Jack. When a working port is detected
and the polarity is correct (pin 3+ and pin 4- ), the center LED will blink and the left LED will turn on steady. If both LEDs are
not indicating as described, stop the installation and verify the M1 port is working at the intended jack with a 2616 set. Next,
