Telephony
181
Configuration
You can configure the “PIN Code Telephony” feature separately for each company.
Configuration is done with the following steps:
1.
Call the OpenCom 100 communications system
Configurator
. On the intro-
ductory page, change the
Level
option to
Expert
.
2.
Open the
User Manager
:
User groups
menu page. Click on the
New
button. Enter
a designation into the
Group name
field and select an existing user group as a
template. Confirm with
Apply
.
3.
Then click on the
Change
button. Select the desired
Company
. Activate the
PIN dial
option for the time groups intended. Configure either external authori-
sation or recording of
Connection data
. Confirm with
Apply
.
4.
Open the
Telephony
:
Extended
:
Companies
menu page. Click on the headline of
the company desired (default: “Company 1”).
5.
Under the
PIN dial
header, select the desired
Route
. Select the user group created
by the previous steps for the
User group
setting. Confirm with
Apply
.
You can also use the “Standard” user group or the “External trunk” standard route for
the “PIN Code Telephony” feature. If you configure a special route, you must also enter
a seizure code for this route (
Telephony
:
Trunks
:
Route
menu, setting:
Code
).
Activate the
PIN dial
user group option for all terminals which are to have the “PIN
Code Telephony” feature available to them. This can also be the “Guests” user group.
Furthermore, you can also use the “PIN Code Telephony” feature for users who have
no terminal assigned to them (“virtual users”).
Implementation
You would like to use the “PIN Code Telephony” feature from any telephone. To do so,
the telephone belonging to another user is switched to your personal user account
(“identity change”). Carry out the following steps:
1.
Call the main menu on a system telephone. Select the
6 Connections
:
7 PIN
dialling
menu entry. Enter your call number and your user PIN. If the entry is
correct,
<PIN dialling>
now appears. Now select the desired external call number
including the seizure route for the “External Trunk” standard route.
You can also initiate PIN dialling with a code procedure:
H#46 Z
(your no.)
* Z
(user PIN)
# Z
(external no.)
Summary of Contents for OpenCom 100 series
