Model VentureIP 480i User Guide
4
Installation
Connecting When Inline Power is Not Provided
1
. On the back of your phone, connect the Ethernet cable (provided with your
phone) into the network port marked with
l
.
2
. On the PoE power supply, plug the other end of the Ethernet cable into
the network jack marked as shown in the following diagram.
3
. On the PoE power supply, connect an additional Ethernet cable into the
network port as shown in the following diagram.
4
. Plug the other end of the Ethernet cable into the network jack on the wall.
5
. Plug the PoE power supply into a power outlet. You should connect
the power supply to a surge protector or power bar.
Note:
All Ethernet cables must be category 5/5e straight-through cables, such as
the cable provided with your phone.
Connecting the Handset
1.
Turn the phone over and locate the handset jack marked
j
.
2.
Insert one end of handset cord into the jack until it clicks into place.
3.
Route the handset cord through the upper groove as shown in
the diagram below.
4.
Attach the handset to the other end of the handset cord.
To Handset
Summary of Contents for VentureIP Gateway
Page 1: ...USER GUIDE Telephone System IP...
Page 47: ......