AMT/PTD/TR/0020/2/7/EN
10/2008
Page 11-186
Chapter 11 - Programming for NeXspan 50
or NeXspan 500 PBXs
11.1
Introduction
The DECT service programming steps are described for NeXspan 50 or NeXspan 500 PBXs.
Note:
It is essential to follow the programming order given.
1
Deactivate the fibre tests (loop tests)
MMC XCALEN (Value 31)
2
Check the "local" type data routing
MMC XACHEM
Caution
: do not forget the network dialling code for a multisite configuration.
3
Declare the TELBOR server
To download to the base stations: RHM XTGTOT (Total sub-group number 4).
4
Declare the radio zones
MMC XSERVI
In a multisite configuration, a cluster routing must be created in all the sites.
5
Declare the company/department profile
Associate a company profile using the MMCs XSERAC/XACHMT (Object COMPANY-
DEPT.) or the RESSOC tool (this requires a system reload).
6
Put the cards in service
To position and put into service LDS/LDT (software variant 23 for LDS and 28 for LDT)
cards, use the MMC XETBLS.
Caution
:
A 16-interface LDS/LDT card can only be fitted as a card with 16 line interfaces
(it cannot be fitted as an 8-interface card and the two cards are not
interchangeable). An 8-interface LDS/LDT 8 card always uses an entire trunk
(32 time slots), a 16-interface card uses 2 trunks (64 time slots).
7
Declare the cells
MMC XCELLU, Object: cells, registration zones: .0.
Start the declaration with cell 0 for single-site configurations (for multi-site: see chapter 13
Multi-site programming).
Summary of Contents for X Series
