Page 12-201
10/2008
AMT/PTD/TR/0020/2/7/EN
•
DIR. BEGINNING ASSIGNED TO LLP: 4 digits maximum, 999 is the default.
The base stations are connected to the PBX via an S0 Basic Rate Interface. One PLL (D
channel) is used for signalling and downloading to the base stations. PLL directory numbers
are comprised of digits recorded in this parameter followed by the base station declaration
order number.
Example: 999000, 999001, 999002, etc.
SEARCH FOR MOBILE
•
IN THE LOCAL SITE
NOYES
Indicates whether the cordless handset must be searched for on the local site or on another
site.
•
OR IN ANOTHER SITE
Name of the site where the cordless handset must be searched for.
•
OR IN THE LOCAL CENTRE
NOYES
Indicates whether the cordless handset must be searched for on the local centre or on
another centre.
•
OR IN ANOTHER CENTRE
Name of the centre where the cordless handset must be searched for.
•
OR ON THE LIST
Select the (BROADCAST) list on which the cordless handset must be searched for.
•
CLOCK SYNCHRON: this line is used to configure the synchronisation of DECT clocks.
3 possible selections: "Priority master", "Not priority master", “Slave”.
•
Single-site case: the default value for a site is “Priority master” (the is supposed to be
standalone).
•
Case of multi-site configuration: in simplex mode, a single PBX is set to "Priority master”
and provides the DECT synchronisation signal for the entire multi-site network. Other
PBXs are configured as "Slaves". In duplex mode, two PBXs are masters (one "Priority
master” and the other “Not priority master”) and can provide the DECT synchronisation
signal for the entire multi-site network, while other sites are configured as “Slaves”(see
Chapitre 11 for a multi-site configuration in simplex and duplex mode).
•
CURRENT STATUS: the read-only line gives the current state of DECT synchronization. The
possible states are: “transmitter”, “transmitter netwk clk”, “transmitter local clk”, “receiver”,
“receiver not OK”, “receiver polarity OK”, and “receiver polarity not OK”. It is thus possible to
know:
•
whether the clock is taken from the network or the local clock,
•
whether a slave site takes its synchronisation from the master or if it has become
transmitter due to a link problem with the master,
•
whether the cable polarisation is correct.
Note:For a multisite network, additional parameters appear, making it possible to define the list of
sites on which the mobile terminals will be registered.
Summary of Contents for X Series
