Page 8-169
10/2008
AMT/PTD/TR/0020/2/7/EN
8.6.5
F6/F1 or F6/F6 contiguous multi-site configuration in simplex
mode
The secondary port of the “Master” PBX is connected to the primary port of the “Slave” PBX.
The base stations must be wired in two pairs. The synchronisation signal is carried by the M bit in
the S frame.
Note:
If the DECT base stations are connected to the integrated S0 accesses of the
NeXspan S CPU card, a third pair is required for synchronisation.
Note:
The LD4X (removing jumper J14 from an LD4NX card and offering additional functions)
is only compatible on the NeXspan S/L/D range and as of software release R4.1.
(*) Minimum of OCT4 card on F1
Figure 7-23: F6/F1 or F6/F6 contiguous multi-site configuration in simplex mode
LD4
F6 MASTER
P
S
LD4
F1 or F6
SLAVE
DECT BASE STATIONS
DECT BASE STATION
IP or T2 link
P
S
PBX_MATRIX_MULTISI
TE_SIMPLEX_01_01
Summary of Contents for X Series
