AMT/PTD/TR/0020/2/7/EN
10/2008
Page 2-44
2.4.2 Configuring a mobile terminal M910/M915
Registering a mobile terminal M910/M915
It is important to follow the procedure below when registering the M910 for the first time.
1
On the mobile terminal, the line "Register" is displayed. Press the
Menu
key, select System
using the
keys and confirm with
OK
.
2
Select Register using
and confirm with
OK
.
3
The line "PARK ? :" appears. Do not make any entry. Press
Next
.
4
The line "BS-PIN" appears. Enter the mobile terminal number (4 digits) and confirm with
OK
.
5
The line "Name" appears. Enter the name of the PBX on which the mobile terminal has just
been registered and press
OK
to confirm.
6
The line " Int No." appears. This is a user information line. The number of the mobile can be
entered here, for example, or the number to be called if the mobile is lost. Enter the
information and confirm with
OK
.
7
The mobile terminal must be configured on the previously registered base station. Select
"Menu, System, Select base station (choose the base station corresponding to the name
entered in 5)"
Note:
After registering the mobile terminal, to change the PBX name and/or the Int No., use the
selection "Menu, Device, OK, Save, OK, Opt, Edit; enter PBX name, OK; enter Int No.,
OK”.
Cancelling a registration
When the mobile terminal is registered on several base stations, to cancel the registration on a
non-selected base station, proceed as follows:
1
Press the
Menu
key, select System using the
keys and confirm with
OK
.
2
Select Register using
and confirm with
OK
.
3
Select the base station to be deleted using the
keys.
4
Press the
Opt
key, select Delete using the
keys and confirm with
OK
.
If the mobile is registered with a single base station, refer to the Installer menu.
Call rejection function
There are two options when an incoming call is received.
•
The sil (silence) function removes the ring tone without interrupting the call.
•
The rej (reject) function allows the calling party to suddenly hang up. When the function is
activated, a “Wait” message is displayed for 35 seconds. The mobile terminal can no longer
receive or make calls within these 35 seconds (busy tone). To seize the line after rejecting a
call, just activate the “PLD” (line seizure) key.
À
¿
À
¿
À
¿
À
¿
À
¿
À
¿
Summary of Contents for X Series
