Page 4-89
10/2008
AMT/PTD/TR/0020/2/7/EN
4.5.5 Connecting base stations
Each terminal is connected to an ISDN S0 (BRI) interface of an LD4NX ST card, and uses two
pairs: 1 transmit pair and 1 receive pair.
Note:
If there are a DECT base station and an S0 terminal (other than the base station) on the
same card, the base station must be powered with a 40 V supply.
Figure 4-8: Connecting a base station to an S0 interface of an
LD4NX
ST card
S0 interface link with DECT base station:
Table14: S0 interface link of an LD4NX ST card with a DECT base station
4-pin STOCKO connector
Base station RJ45 connector
Pin 4 (NRD0)
Pin 6
Pin 3 (RD0)
Pin 3
Pin 2 (NED0)
Pin 5
Pin 1 (ED0)
Pin 4
LD4N card
J7
J8
J9
J10
Identical
SYNCHRO
Radio
Base
Station
Summary of Contents for X Series
