20
7 1 Driving with the CAMILINO
Observe chapter 9 - Fault conditions and troubleshooting
In the event of longer breaks, the automatic switch-off switches the CAMILINO off after a maxi
-
mum of 10 minutes
Pull out the release button
for the drive unit to above
the green marking. The drive
wheels move downwards.
Press the ON/OFF switch.
The LED is
lit
continuously
green = ready to drive!
LED
is flashing
green = pull
the release button until the
green marking becomes vis-
ible.
Battery capacity
The LED provides informa-
tion about the charge level.
i
Manufacturer's note:
»
The LED is lit green = charge level between 60 - 100 %
»
LED is lit yellow = charge level between 20 - 60 %
»
LED is lit red = charge level below 20 %
- It is mandatory to recharge the battery.
»
If the LED lights up red several times, refer to
chapter 9 1 - Fault conditions
i
NOTE - Fold up the anti-tip support to overcome kerbs/obstacles, because otherwise it could
be damaged.
i
NOTE - Always switch the CAMILINO to "ROLL" to move at idle speed, otherwise it cannot be
pushed.
i
NOTE - Never use the handle unit of the CAMILINO to pull/lift, because it has not been de-
signed for this. Use the pushing handles of the wheelchair.
i
NOTE - Only drive up to walls with the anti-tip support folded up so as not to damage it.
i
NOTE
- Before first start-up, the battery pack must be fully charged!