Standard controller –
Installation manual
AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
All rights reserved.
11
9. Adding cards to controller memory without software
3000 series controllers have ability to add cards to the controller database, using
connected standard reader, without connecting with management software.
It
’
s very useful function on system commissioning and testing stage, because it
allows fast and simple adding of cards with privileges. Using this method, up to
3000 cards can be added, all with administrator rights and working in 7/24h
mode. After communicating controller with the software, at a further stage of in-
stallation, it is possible to remotely delete these cards, but they are not overwrit-
ten by cards added with the software. If we want to have uniform card database
in entire system, obviously cards added with this method should be deleted and
card database should be sent from the management software on PC. Function of
adding cards with this method is enabled as default, but it can be disabled after
connecting controller with the software. Adding cards using reader affects only
database of controller, to which reader used for reading cards is connected. If
system consists of more controllers, this procedure should be repeated individu-
ally for each controller.
Procedure for creating programming card:
1.
Push the button
Mode
, located on the upper edge of controller and hold it
for 3 seconds. Read any card in the reader
-
it will be programming card. To
exit programming mode, push the button twice and wait for 30 seconds.
Procedure for adding cards to the controller memory:
1.
Read programming card in the reader once. Entering to programming mode
is indicated by blinking LED on the reader alternately, in red and green.
2.
Read card, which should be added. LED on the reader will flash in red for
1,2 seconds. It indicates adding card. Read further cards, which should
be added.
3.
In order to finish procedure of adding cards read the programming card
again or wait for 12 seconds.
Procedure for deleting cards from controller memory:
1.
Read the programming card in the reader twice. Entering to programming
mode is indicated by LED on the reader flashing green.
2.
Read the card, which should be deleted. LED on the reader will flash in red
for 1, 2 seconds. It indicates deleting card. Read further cards, which should
be deleted.
3.
In order to finish procedure of adding cards read the programming card
again or wait for 12 seconds.
Procedure for deleting all cards from controller memory:
1.
Read the programming card in the reader three times. Entering to program-
ming mode is indicated by LED on the reader flashing green.
2.
After 4 seconds read programming card again. All cards are deleted and
reader will leave the programming mode.
Summary of Contents for KaDe KDH-KS3012-IP
Page 12: ......