2
Mounting and initial operation
Max-e may only be operated in connection with a special holding device,
which must be fixed to the wheelchair.
These brackets (holding devices) must be mounted to the wheelchair exclu-
sively by AAT Alber Antriebstechnik or their authorized dealers.
2.1
Brackets
The holding devices or brackets are specially developed and adjusted to
each particular type of wheelchair. The brackets in this picture
,
right and
left may look different from the ones on your wheelchair
.
F
Please make sure that the brackets are tightly secured on the chair befo-
re each use. Do not use the max-e if the screws are loose. In such case
contact your dealer immediately
.
F
Please note that mounting the max-e to a wheelchair (depending on the
model) may result in restricting the adjustment of its seat or back rest
.
F
Mounting the max-e to a wheelchair (depending on the model) may re-
sult in a change of the wheelchair’s measurements
.
2.1.1
Attach and detach the wheels
There are full-floating axles in the centre of your wheelchair wheels. Press
the locking pin in the middle of the axle with your index finger to unlock the
system. Now you can take the wheel off.
Please remove one after the other
.
To put the wheels back on proceed in reverse order
.
2.2
Battery pack
Underneath your wheelchair’s seat there is a bag attached for the battery
pack. You slip the battery pack into the bag
...
...and secure it with a Velcro strap
.
8
max
-
e
