3.6
Removing the vertical lift
1. Stand behind the carrier device and
loosen the locking bolts at the two up-
per handles by pulling and turning them. Now the handles are unlocked
.
2. Hoist the vertical lift at its two bars until the handles are lifted out of the
carrier device’s horizontal bar.
3. Now the vertical lift can be pushed away from the carrier device.
3.7
Load pick-up
Push the load a bit backward so that there is a space. Move the blade under
the load and push it all the way onto the blade.
F
Please make sure that the load touches the back bar.
F
Please make sure that the maximum lifting capacity of 100 kg is not
exceeded.
3.8
Driving on level ground
To drive on level ground the load needs to be in the lowest position possible
in order to keep the centre of gravity as low as possible.
3.9
Driving on slopes
If you want to drive up a ramp, you must tilt the vertical lift.
Tip: Put your foot on the horizontal bar and tilt the device backwards.
15
Vertical lift V1001
Summary of Contents for V1001
