background image

 

EU Declaration of Conformity 

Hereby, Aava Mobile declares that this device is in compliance with the essential requirements and other relevant 
provisions of Directive 1999/5/EC. 

 

      

 

 

 
 

FCC Compliance Statement 

15.21 
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance  could 
void the user’s authority to operate the equipment. 
15.105(b) 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to  
radio or television reception, which can be determined by turning the equipment off and on, the user is e ncouraged to try 
to correct the interference by one or more of the following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: 

1.

 

this device may not cause harmful interference and 

2.

 

this device must accept any interference received, including interference that may cause undesired operation 
of the device. 

 

Canadian Compliance Statement 

This Class B digital apparatus complies with Canadian ICES-003. 

Cet appareil numérique de classe B est conforme à la norme NMB-003. 

This device complies with Industry Canada licence-exempt RSS standard(s).

 Operation is subject to the following two 

conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including 
interference that may cause undesired operation of the device. 

Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence(s).

 Son fonctionnement est soumis aux 

deux conditions suivantes: (1) cet appareil ne peut pas provoquer d'interférences et (2) cet appareil doit accepter toute 
interférence, y compris les interférences pouvant entraîner un mauvais fonctionnement de la appareil. 
 

For Local Area Net operation (RSS-210 A9.4 sections (6-7)):

  

(1) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful 
interference to co-channel mobile satellite systems; 
(2) high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz 
and that these radars could cause interference and/or damage to LE-LAN devices 

(1) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés uniquement pour une utilisation à l'intérieur 
afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux; 
(2) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont désignés 
utilisateurs principaux (c.-à-d., qu'ils ont la priorité) pour les bandes 5 250-5 350 MHz et 5 650-5 850 MHz et que ces 
radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL. 

 

Summary of Contents for Inari 10









Reviews: