31
3. Remove the foam from air filter.
4. Check and clean the air filter, replace
with a new one if the element is
damaged.
5. Good air filter can be washed in soapy
water, dried and reused.
CAUTION
Do not wring out the foam element when
squeezing it. This could cause it to tear.
6. Oil the foam and squeeze out excess
oil. It should be wet but not dripping.
7. Wipe off excessive oil from the air
cleaner case. Small amount of oil in the
element is normal and necessary for the
engine to work properly.
8. Reinstall the air filter element, replace
the air filter cover in its original position.
9. Reinstall the access panel and tighten
the screw.
1) put the screw #1 & 4 in the access
panel, but donot tighten it fully.
2) put the screw #3 & 6 in the access
panel, but donot tighten it fully.
3) put the screw #2 & 5 in the access
panel, but donot tighten it fully.
4) tighten all screws well
CAUTION:
Be sure the foam element sealing
surface to match the air filter case, so
there is no air leak.
The engine should never run without
the element; excessive piston and
cylinder wear may result.
Never use solvent while smoking or in
the vicinity of an open flame.
Running the engine with dirty,
damaged or missing air cleaner
element will cause the engine to wear
out prematurely.
MUFFLER SCREEN AND SPARK
ARRESTER
WARNING:
The engine and
muffler will be very hot after
Summary of Contents for A112003
Page 37: ...37 WIRING DIAGRAM...
