34
4) tighten all screws well
11. Start generator without any device
connected to it until it stops. This burns
out the any fuel in the carburetor.
CAUTION
• Do not connect with any electrical
devices.
• Duration of the running engine
depends on the amount of the fuel left
in the tank.
NOTE:
Slightly tight the screw at first. Do not
tight the screws too firmly.Until all
screwed into, and then tightened firmly.
12. Store the emptied gasoline in a
suitable place.
CAUTION:
Do not store fuel
for more than 3 months.
DRAIN THE ENGINE OIL
Refer to the “CHANGING/ADDING OIL” in
the “MAINTENANCE”
ENGINE
1.
Remove the spark plug, pour about
one table- spoon of SAE 10W30 or
20W40 motor oil into the spark plug
hole and reinstall the spark plug.
2.
Pull the Choke knob to out
OFF
position. Recoil start the engine by
turning over several times (with
ignition off) to coat the cylinder walls
with oil.
3.
Pull the recoil starter until you feel
compression. Then stop pulling. (This
prevents the cylinder and valves from
rusting).
4.
Clean exterior of the generator.
5.
Store the generator in a cool,dry,
well-wentilated place, with the cover
placed over it.
6.
Do not obstruct any ventilation
openings.
7.
The generator must remain in a
vertical position when stored, carried
or operated.
8.
If the generator is being stored for
short periods of time (within 30 days),
add stabilized fuel to the fuel tank until
full.
NOTE:
Filling the tank reduces the
amount of air in the tank and helps
reduce deterioration of fuel. Run the
engine for 2-3 minutes allowing
stabilized fuel mixture to circulate
through the carburetor.
9.
In order to prevent corrosion, please
coat antirust oil on all screw, at least
once half one year.
CAUTION
:
Never place any type of storage cover
on the generator while it is still hot.
TRANSPORTATION
Keep the generator upright. Never
place the generator side down. Doing
so will make it difficult to start.
Tighten fuel cap. Drain the fuel tank if
possible (see “Drain the Fuel Tank”).
Summary of Contents for A112003
Page 37: ...37 WIRING DIAGRAM...
