14
filling will cause oil to flow into engine
areas and will cause damage. Keep
generator level!
2. Loosen the screw and remove the small
panel.
3. Unscrew the dipstick from the engine
and set aside (Keep it clean).
4. Using a funnel provided, add oil slowly
to bring level to full.
5. To check the oil level: wipe the dipstick
with a clean rag. Insert the dipstick into
the oil fill opening without screwing in.
Remove the dipstick to check the oil
mark.
6. Slowly add more oil and repeat step 5
until the oil mark reaches to the top of
the dipstick. Do not over fill the
crankcase. The generator is equipped
with a low oil sensor and will not start if
the amount of oil is insufficient.
7. Check for oil leaks. Tighten dipstick
firmly before closing the access panel.
Step 2-ADD GASOLINE
DANGER:
This generator
may emit highly flammable
and explosive gasoline vapors, which
can cause severe burns or even death
if ignited. A nearby open flame can
lead to explosion even if not directly in
contact with gasoline.
Use fresh (within 30 days from purchase),
kead-free gasoline with a minimum of 87
octane rating. Do not mix oil with
gasoline.
To add gasoline, follow these steps:
1. Make sure the generator is on a level
surface.
2. Remove the fuel tank cap and set aside
(Keep it clean).
NOTE:
The fuel cap may be tight and
hard to unscrew.
3. Slowly add unleaded gasoline into the
fuel tank until fuel indicator in the fuel
level gauge moves to the “MAX” from
the “MIN”.
Be careful not to overfill. The capacity of
the fuel tank is 3.9 US gallon.
NOTE:
Do not fill above the top of the
Summary of Contents for A112004
Page 39: ...39 WIRING DIAGRAM...
