38
1.No fuel in tank
Refuel
2.Clogged fuel line
Clean fuel line
3.Clogged carburetor
Clean carburetor
4. Air filter is dirty.
Clean or replace air filter.
5.Faulty ignition system
Consult service center
Engine
stops
Not enough oil in crankcase
Add or change oil
Engine is out of fuel
Add fuel.
Blue smoke
in exhaust
Generator inclined, oil
entered combustion
Move generator to a level position
Too much oil was added to
the crankcase.
Drain excessive oil.
Generator
runs but
does not
support all
electrical
devices
connected.
Bad connecting wires/cables. If using an extension cord, try a different one.
Bad electrical device
connected to generator.
Try connecting a different device
Generator is overloaded,
Overload light is on
Perform these steps: 1. Turn
off
all electrical
devices. 2. Unplug all electrical devices. 3. Shut
down the engine. 4. Wait several minutes and
then start the engine. 5. Try connecting fewer
electrical loads to the generator.
Short in one of the
connected devices.
Try disconnecting any faulty or short-circuited
electrical loads.
Generator
does not
produce
power
Safety device (DC protector)
to “
OFF
”
Press the DC protector to “
ON
”
The AC pilot light (Green)
go
off
Stop the engine, then restart
Summary of Contents for A112004
Page 39: ...39 WIRING DIAGRAM...
