7
KNOW YOUR HEDGE TRIMMER
1. Impact Guard
2. Safety Guard
3. Safety Switch
4. Front Handle
5. Up/Down
Rotary Switch
6. Rotating
Handle Lock
7. On/Off Switch
8. Rotating Rear
Handle
9. Blade Cover
10. Battery
Pack
11. Battery
Charger
ASSEMBLY
BLADE COVER
WARNING!
Ensure the hedge trimmer is
disconnected from the power supply before removing
cover and preparing for use.
Fitting and Removing the Blade Cover
The hedge trimmer comes with a blade cover to
protect the blades when storing. The blade cover must
be removed prior to operation.
1. Slide the blade cover off the blade.
2. To fit, slide the cover back over the blade.
WARNING!
Never use the hedge trimmer with
the blade cover fitted.
SAFETY GUARD
1. Make sure that the safety guard is attached
securely.
BATTERY & CHARGER
Do not expose the battery to extreme condition such
as heat impact. Risk of injury from escaping
electrolytic solution. After eye/skin contact rinse the
affected area with water or a neutraliser and consult a
doctor.
Charge the battery in a dry room only. Prior to
attaching the charger, check that the battery’s outer
surface is clean and dry. There is a risk of injury due to
electric shock.
Only use the charger (AAVIX) to charge the cattery.
Mind not to charge the appliance for more than 5 hour
at a time. If you do, the battery and the appliance may
be damaged and longer charging times would be a
waste of energy. Excessive charging will void the
warranty.
Charge the battery before the first time of use. Do not
briefly charge the battery several times in row.
1.
To remove the battery pack from the appliance,
press the release button on the battery pull out the
battery.
2. To insert the battery pack, place it on the guide
track and push it back into the appliance. It will audibly
snap in .
3. Recharge the battery, when all the green light put
out and only the last red light is bright on the battery
pack.
