24
15. If you carry out several cuts without
letting go of the product, always turn
off the product between cuts.
Holding The Unit
1. Place the holding belt as shown in
the image and click onto the product
using the ring.
2. Always grip the unit firmly with both
hands when the unit is running.
3. Hold the product with the left hand
on the handle and with the right hand
on the rear handle in such a way that
you can act over the control switches
(locking switch and trigger switch)
with your right hand.
WARNING:
To reduce the risk
of loss control and possible damages
(that could be mortal) to the user or
bystands, NEVER use the product one
handed.
4. Always maintain both feet on the
ground and only action the pruner saw
when you are on a flat and stable
surface. Maintain your body on the
left side of the unit.
5. Maintain the pole saw at a
maximum 60 degrees from the ground
and maintain an adequate safety
distance from the branch being cut.
6. Maintain an adequate safety
distance from the branch being cut.
Where the branch will fall and make
sure you are not in that area. The safte
distance should be at least double the
length of the branch being cut.
7. Firmly encircle the handles and/or
pole with the thumbs and fingers.
This will help reduce the chance of
losing control of the unit if kickback
occurs. Any grip with thumbs and
fingers on the same side of the handles
and/or pole is dangerous.
8. Stand in a stable position with feet
apart and firmly planted.
9. Hold the pole with the left hand.
Keep the left arm straight. Always hold
the pole in the grip area.
10. Hold the handle with the right hand.
Keep the right arm slightly bent
11. Hold the unit at waist level .
12. Do not extend arms above shoulder
height. Do not overreach.
