Getting Started
1. Connect the power cord to the P700.
2. Connect the wall plug into the wall power source.
3. Toggle the On / Off switch on the side of the projector to the “ON” position. (the
projector should automatically turn on)
4. If the projector does not automatically turn on with the “Power Switch” toggled to the
“ON” position, press the “ON/OFF POWER” button on the keypad and hold for 2-3
seconds to start the projector.
4
Powering ON the projector
Chapter 2
Standby Mode
1. Press and hold the power button on the keypad or remote until a blue message box
appears on the screen.
2. The blue message box will prompt you to press the POWER button once more.
3. The optical engine should power off and the fan should stop spinning. The projector
is now in “stand by mode” and can be turned on using the remote control.
Note: “Stand by mode” consumes a little bit of power
Note: The P700 Projector battery does not charge when it is in operation.
Powering OFF the projector
1. To turn off the projector, toggle the POWER Switch to the “OFF” position once you
are in “standby mode”. This will fully turn off the projector.