Chapter 6
Programming
6-8
Parameter Descriptions
This section lists and describes the various parameters currently available
(software version 2.01). Not all parameters will be available in every
parameter level. Refer to the “Parameter Type” classification in each
description for further information. In addition to the Parameter Type, each
description (when applicable) will also provide Minimum, Maximum and
Default Values. Please note that parameter numbers not listed are reserved
for future software enhancements.
Important: Parameter names followed by an asterisk (*) should not be
modified. These parameters are provided for information purposes only.
ATTENTION: To guard against personnel injury and/or
machine damage caused by improper programming, parameter
names followed by an asterisk (*) should only be modified by
qualified personnel.
!
Parameter 00 – Reset Display Faults (Rst Disp Flts)
This parameter clears display faults.
Parameter Type:
View/Modify in Maintenance level only
Parameter 03 – Drive Size *
The current drive size in amperes (as read from the drive on power-up) is
contained in this parameter.
Parameter Type:
View only, all levels
Parameter 04 – Adapter Type *
This parameter is not active at this time.
Parameter Type:
View only in Maintenance level
Parameter 05 – Logic Command (Logic Comd) *
This parameter contains a 16 bit, bit encoded, binary word that represents
the logic commands from an adapter board. A bit set to “1” indicates that a
condition exists. If a “0” is displayed that condition does not exist.
Parameter Type:
View only in Maintenance level
Summary of Contents for 1391-DES Series
