Solares
TM
Smart Spa Parts Manual
CD0039
10
Rev:1121
4.
Disconnect union at top of manifold by placing one wrench on the bottom of the union and
another on the nut.
5.
Disconnect White PVC line from dual check valve assembly by loosening hose clamp and
removing tube.
6.
Disconnect fill hose, shower hose, and reservoir hose (if applicable.)
7.
Disconnect Cleaner & disinfectant lines.
8.
Disconnect part #6.
9.
Remove part #4 (X4) using Philips head screwdriver and remove manifold from frame.
10.
Remove union from top of old manifold and install it into new manifold. 3 wraps of thread tape
with coating of PTFE thread sealant on top is recommended for most reliable seal.
11.
Install new manifold onto plate using part #4 and part #5 as shown.
12.
Reinstall all hoses and connections removed in previous steps.
13.
Turn water back on and use touch screen to verify all valves connected properly and that there
aren’t any leaks.
Part #2
–
Chemical Injector; 3/8 MPT; Plastic
1.
Remove cleaner/ disinfectant hose from injector tip.
2.
Use small flat head screwdriver to pry separate teeth of hose clamps adjacent to injector & pull
hose off barb. Note: If you have ½” Vinyl tubing available it is often easier to carefull
y cut along
the length of the tubing to remove it from the barbs and simply replace it as it can be stubborn.
3.
Twist injector counterclockwise to remove from street elbow.
4.
Remove barb & metering tip from old injector and install on new injector.
5.
Install new injector into street elbow.
6.
Replace hose over injector barb and reinstall hose clamps.
7.
Replace cleaner/ disinfectant hose.
Part #6
–
NTC Thermistor; 10Kohm
1.
Disconnect thermistor from cable.
2.
Unthread thermistor from manifold.
3.
Remove M8 connector from thermistor and install it on the new thermistor per WI0107.
4.
Thread new thermistor into manifold using thread tape to seal.
5.
Connect M8 connector.
6.
Clear thermometer error through hitting the “Reset Error” button under maintenance or by
cycling the tub’s
power.
7.
Calibrate thermistor per instructions in Solares Operation manual.
Part #7 - Series 35KR; 2-way-2pos valve
1.
Disconnect DIN cable by loosening screw on back of connector all the way and pulling connector
away from valve.
2.
Turn off hot/ cold water supply.
3.
Use touch screen to open tub or shower valve to bleed pressure from lines.
4.
Use Philips screwdriver to remove all 4 screws securing valve to manifold.
