10 NETernity* RM921N / RM921ND Hardware Reference Manual
Publication No. 597-0000000013-000 Rev. F
1.3 Safety Summary
The following general safety precautions represent warnings of certain dangers of
which Abaco Systems is aware. Failure to comply with these or with specific
Warnings and/or Cautions elsewhere in this manual violates safety standards of
design, manufacture and intended use of the equipment. Abaco Systems assumes no
liability for the user’s failure to comply with thes
e requirements. Also follow all
warning instructions contained in associated system equipment manuals.
WARNING
Use extreme caution when handling, testing, and adjusting this equipment. This device may operate in an
environment containing potentially dangerous voltages.
Ensure that all power to the system is removed before installing any device.
To minimize shock hazard, the chassis and system cabinet must be connected to an electrical ground. A
three
‐
conductor AC power cable should be used. The power cable must either be plugged into an approved
three
‐
contact electrical outlet or used with a three
‐
contact to two
‐
contact adapter with the grounding wire
(green) firmly connected to an electrical ground (safety ground) at the power outlet.
1.3.1
Do Not Operate in an Explosive Atmosphere
Do not operate the system in the presence of flammable gases or fumes. Operation of
any electrical system in such an environment constitutes a definite safety hazard.
1.3.2
Keep Away from Live Circuits
Operating personnel must not remove product covers. Component replacement and
internal adjustments must be made by qualified maintenance personnel. Do not
replace components with power cable connected. Under certain conditions,
dangerous voltages may exist even with the power cable removed. To avoid injuries,
always disconnect power and discharge circuits before touching them.
1.3.3
Do Not Service or Adjust Alone
Do not attempt internal service or adjustment unless another person capable of
rendering first aid and resuscitation is present.
1.3.4
Do Not Substitute Parts or Modify System
Because of the danger of introducing additional hazards, do not install substitute
parts or perform any unauthorized modification to the product. Return the product
to Abaco for service and repair to ensure that safety features are maintained
1.3.5
Handling
Only handle the RM921N by the edges, ejector handles or front panel.
