Abacus Pisces 069/Info.P 04/14v1a
16
0808 256 4249
Installer - Testing the Bath
WARNING!
The system batteries must be charged for 24 hours prior to using the bath. You may test the bath to ensure
it is working correctly.
Ensure that hands and objects are kept away from the underside and topside when operating the bath.
Ensure the floor area around the bath is kept free from excess water to avoid persons slipping.
Do not allow unauthorised persons to operate this bathing system.
This Bath moves. Ensure there are no objects or persons that can become trapped or injured while the
bath raises or lowers.
BATH OPERATION
To operate the unit:
The handset control buttons are completely safe to use with wet hands, The up/down buttons operate
independently on a ‘depress–to–run’ basis, in that movement will stop if the button is released.
Make sure the bath is in the fully lowered position using the Handset DOWN button.
Check the pop up waste is in the fully closed position. Ensure the platform is in the fully lowered position
and the platform retaining mechanism is working.
Fill the bath approximately half full with water. Check the water temperature is within safe bathing limits
40°- 43°.
Raise the bath using the UP button on the handset.
Empty the water whilst the bath is in the up position as this will help with the draining of the bath. Fully
lower the bath using the DOWN button on the handset. Clean the bath as per the cleaning instructions.
Ensure the Platform can easily be lifted by the front edge for cleaning underneath.
WARNING
In the event of mains failure during use of the bath, back-up batteries will enable the bather to exit the
bath. Do not carry on using until mains power is restored.
