10
PAS600 SPECIFICATIONS
FEATURE
SPECIFICATIONS
Net weight with filters:
33.5 lbs.
Shipping weight:
42.5 lbs.
Unit dimensions:
23.75” L x 18” W x 17.5” H
Power supply requirements:
Minimum
120 VAC, 60 Hz, 15 A
Normal operating amps:
1.9 amps or less
Integrated circuit breaker:
12 amps
Motorized impeller:
225 watt motorized impeller with thermal overload protection, auto
re-set, 60 Hz, single phase.
Operating flow rate* (with clean filters):
Variable, 200 – 600 CFM
Operational sound level:
62 – 67 dBA on high speed, reading taken at 5’.
Cabinet:
.050 anodized aluminum, assembled with solid rivets. Seams
are gasketed.
Transportability:
Carrying handles on top of unit.
Stackability:
The 4 plastic guides on top panel and 4 rubber feet on bottom
panel enable up to 3 units to be stacked.
Pre-filter access:
Swing out hinged door secured in place with cam latch.
First stage pre-filter:
1" deep coarse particulate pre-filter (P/N: F621).
Second stage pre-filter:
2" deep pleated particulate pre-filter (P/N: H502).
Alternate second stage pre-filter:
2" deep high capacity carbon filter for odors (P/N: VL1002).
HEPA filter:
HEPA mini-pleat filter with continuous seamless gasket, tested
and certified to an efficiency of 99.97% or higher against 0.3
micron size particles (P/N: H161606-99).
Note:
Specifications subject to change without notice.
*Airflow rating estimates are based on factory testing at 120 VAC, 60 Hz with an air straightener and a traverse
of readings taken with a computing vane-anemometer. Actual results may vary for various reasons, including
motor and blower and HEPA filter tolerances. Factors such as filter loading, reduced voltage to the motor, and
inlet and outlet ducting will reduce airflow. Use the ratings as a general guideline only.