VETSCAN SA USER’S MANUAL
v
1.1 SOFTWARE
|
4 3
Appendix F:
Safety and Regulatory Compliance
Safety Warning Labels
Warning labels posted on the analyzer and in this manual warn you about potential sources of
injury or harm. Refer to the Symbols Table to review the meaning of each safety warning label.
Use only the provided power supply and cable when connecting the SA analyzer.
The SA analyzer has been tested and found to be in compliance with all applicable requirements
of the following safety and electromagnetic standards:
Safety Compliance
• IEC 61010-1:2010 Safety Requirements for Electrical Equipment for Measurement, Control
and Laboratory Use, Part 1: General Requirements
• IEC 61010-2-081:2015 Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory use, Part 2-081: Particular Requirements for automatic and semi-
automatic laboratory equipment for analysis and other purposes
• CAN/CSA-C22.2 No. 61010-1-12 Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use – Part 1: General Requirements
• UL 61010-1:2012 Safety Requirements for Electrical Equipment For Measurement, Control,
And Laboratory Use – Part 1: General Requirement
Electromagnetic Compatibility (EMC)
• IEC 61326-1:2012 Electrical Equipment for Measurement Control and Laboratory Use – EMC
Requirements – Part 1: General Requirements, Class A
• EN61326-1:2013 Electrical Equipment for Measurement Control and Laboratory Use – EMC
Requirements – Part 1: General Requirements, Class A
• EN 61326-2-6:2013 Electrical Equipment for Measurement, Control And Laboratory Use –
EMC Requirement- Part 2-6: Particular Requirements – In Vitro Diagnostic (IVD) Medical
Equipment
• FCC Part 15 Subpart B:2016
FCC Warnings and Notes
• Warning: Changes or modifications to this unit, not expressly approved by Abaxis, could
void the user’s authority to operate the equipment.
• Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable production against harmful interference when the equipment is operated in a
commercial environment. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference, at his
own expense.
• Note regarding FCC compliance. Although this analyzer has been tested and found to
comply with Part 15, Subpart B of the FCC Rules for a Class A digital device, please note that
this compliance is voluntary, in regard to the cited FCC regulations in effect at the time of
manufacture.
• Note regarding Canadian EMC compliance: This digital apparatus does not emit radio
noise exceeding the limits for class A digital apparatus prescribed in the Radio Interference
Regulations made by the Department of Communications of Canada.
Waste Disposal
• A re-usable waste bottle is provided with your new VETSCAN SA. Before disposing of waste
from the VETSCAN SA, consult your local waste disposal regulations and the VETSCAN SA
Reagent Kit SDS/MSDS for recommendations.
• For equipment disposal, please consult your local waste disposal regulations.
