2.5.3 Installing an expansion container
Validity of this section
This section is only valid for other design than Type C and Type D.
Introduction to the expansion container
The expansion container is needed on suspended robots (other design than Type
C and Type D) to make sure that the amount of oil in gearbox axis 1 covers all
important parts. Robots ordered as suspended robots have the expansion container
installed on delivery.
Expansion container
xx1000000318
Cover
A
Attachment screw M6x16, quality 8.8-A2F (5 pcs)
B
Oil expansion container with cover
C
Base
D
O-ring D220x5
E
Attachment screw M5x20, quality 8.8-A2F and washer (2+2 pcs)
F
O-ring D1=9.5 D2=1.6
G
Oil plug (to be removed)
H
Required equipment
Note
Equipment
Kit including oil.
Expansion container
Continues on next page
90
Product manual - IRB 4600
3HAC033453-001 Revision: Y
© Copyright 2009-2021 ABB. All rights reserved.
2 Installation and commissioning
2.5.3 Installing an expansion container
Summary of Contents for IRB 4600
