Page 9
© 2023 ABB. All rights reserved.
Edge_I
-
lim_G390_QSG
Version. 2.0
Step 1. Disassemble existing AC connections
Use "Turn off/Lock Out Tag Out".
1.
Turn off AC power supplying the Edge cabinet.
2.
Note which cord is
“
A
”
feed and which is
“
B
”
feed.
3.
Unplug AC cords from the twist
-
n
-
lock input receptacles
at the top of the cabinet.
4.
Disconnect both AC cords/wires from each twist
-
n
-
lock
plug and keep cords for reassembly later.
Step 2. Disassemble AC panel and central panel
1.
Remove the 4 screws which attach the AC input
panel to top of the cabinet so that the panel can be
opened as shown.
2.
Disconnect the black, blue and red wires from each
of the receptacles. Keep track of the wire which is
connected to
“
A
”
and
“
B
”
receptacles.
3.
Remove the 4 screws on the back center panel and
then remove the panel.
Note: Both the AC input panel and the back center panel
will be discarded.
Figure 5 Disassemble AC connection
Figure 6 Twist
-
n
-
lock plug
Figure 7 AC panel removed
Figure 8 Central panel removed
Note: This process is written for a system that is not
providing active load support or that can be
temporarily taken down. If this system is live and
cannot be taken down for the installation duration
period please contact Technical Support to discuss
alternatives.
QUICK START GUIDE
