ENG 14
7 Programming
7.1 Programming
planning
For easy planning of all necessary settings, it makes sense to enlarge the tree
structure enclosed in the annex to DIN A 4 size on a photocopier and to put
these sheets one beside the other. Now enter the desired control times and
parameters here.
After that, programming can be carried out clearly point by point and checked
after completion.
7.2
Programming an example
The exampe below describes the programming of a time block of a blind control.
The actual programming of the timer is done in the same way.
In this example, the blind is to be moved up at 8:10 on Sat and Sun. The
seasonal shifts regarding sunrise and sunset times are to be considered.
However, the blind is not to move up before 6:30.
Press briefly (< 0.5 sec.): the control unit changes to the main menu for
programming.
Activate the first time channel.
, Mark „Time channel 1“ and change to „Time channel 1“.
, Mark “Status” of time channel 1 and change to “Status”.
